|
Efiing AT part 2
A few months ago I was complaining that I couldn't get a 4EAT into my SVX after removing a busted one. I finally got a chance to re-visit it today.
Last time I was advised to lift the transmission up into the car at an angle, with the front end going up first. I tried that today and still had issues with the crap on top of the transmission (clips, tubes) hitting the transmission tunnel.
So, a few questions:
1) do I have to remove the wiring harness from the top of the 4EAT in order to install it?
2) how large an angle does the transmission have to go up at?
3) Can somebody just post either a step by step of 4EAT installation, or maybe even scan in the procedure from the FSM?
I'd like to get this bioatch in today, so any help is greatly greatly appreciated.
Mat
|