View Single Post
  #31  
Old 06-20-2003, 09:31 PM
awdsvx awdsvx is offline
Registered User
 
Join Date: Feb 2003
Location: Germany
Posts: 245
Lightbulb Cage

You do not need to "CUT" the cage. The back end of the cage is held in by four "SPOT WELDS". Just take a drill and drill out the "SPOT WELD's" using a drill and drill bits. Start by using a small one and then prgogressively use bigger ones to drill out until the hole is bigger than the weld. Do it on all four until the back end comes off. This method makes for a cleaner and more professional install.

Last edited by awdsvx; 06-22-2003 at 07:20 AM.
Reply With Quote