|
Re: Will this fit? Universal Bolt Pattern: 5 x 100 + 5 x 115
Enkei Shoguns, am I right? Probably 17x7 or 17x8... Otherwise a knock-off of them.
I've seen pictures of a green SVX wearing those. Evidently, Mike's pre-pearlie car, if this cardomain page is for the same "mike". http://www.cardomain.com/ride/286975
 
Pretty sure they'll fit. 
Most aftermarket wheels are made to fit a wide variety of cars, and a FWD fitment like that should have plenty of positive offset for SVX fitment. They even appear to be directional, if those photos above are accurate, and one isn't mirrored. Both sides of the car have the wheels "clawing forward".
The hub bore diameter is likely pretty wide to fit a variety of cars that might have a wide hub ring diameter, so some hub ring spacers are likely a good idea, and SVX OE lug nuts won't work with those wheels. 12x1.25mm (IIRC) thread pitch for Subaru or Nissan fitment (wheel stud threading), with the same seat style (likely conical) as those wheels will be required. Probably narrow over-all diameter "tuner" lugs. McGard Spline-drives work well for that.
They'd be sexier if they weren't double-drilled, or had fitted center cap covers over the hub area, but those are good lookin' wheels.
__________________
"What you plan, and what actually happens ain't exactly ever been similar..."
------------
1992 Claret SVX. Rescued from certain destruction, and still on the road, where it belongs. Waiting for a bit of a makeover, when I can afford it.
2005 Garnet Red Pearl Legacy GT Limited 5-speed. - The late great Subaru sport touring sedan.
1999 Classic Red Miata, Preferred equipment package 5-speed. Fun, fun, fun, in the Sun, sun, sun.
Last edited by BoxerFanatic; 04-29-2010 at 05:05 PM.
|