|
Re: starter mounting bolt
The stripped hole was about 10mm. I used a 7/16 tap (which is about 11mm) and used a bolt rather than a stud.
I guess a stud was used to make it easier to install the starter. That way you can rest the starter on the stud while threading into the top hole, then tighten a nut on the bottom stud. Anyway, it was a tight squeeze but all is done.
__________________
Father of 5 sons and 1 daughter
Subaru SVX for fun
Hyundai Veracruz for the wife.
Susuki SX4 for my older son
Ford Ranger for work
Mercedes Benz Sprinter for vacation trips,
EZ GO Golf cart for driving kids around gated community.
Last edited by dannmarr; 04-28-2013 at 05:48 PM.
|