Maybe
Elinoalex
The Haynes manual I have says you need to disconnect the Test Mode Connector, and turn the ignition ON. [but don't start the engine] Then you count the blinking of the CE light, the usual way.
To get at it, you need to take off the panel facing the driver's knees. There are two screws to remove, then the panel is only held on with 3 clips on the top edge. Pull panel downwards.
I can't remember the colour of the connector, or the wire, but it's easy to find. It only has one wire to and from. The connector itself is spade terminal [or screwdriver blade] broad at the bottom, then steps in narrow at the top. Pull this apart, turn on the ignition, your CE should blink the codes.
Joe
PS, when you get the codes, I can give you what they mean.
__________________
Black Betty [Bam a Lam!] '93 UK spec, still languishing Betty
Jersey Girl Silver '92 UK [Channel Isles] 40K Jersey Girl @ Mersea
Candy Purple Honda Blackbird Plum Dangerous
White X2 RVR Mitsubishi 1800GDI. Vantastic
40,000 miles Jersey Girl
|