08-14-2008, 04:34 PM
|
 |
Collision Refinishing Tech
|
|
Join Date: Aug 2007
Location: Huntingdon, PA
Posts: 2,279
|
|
|
Re: Finally some progress...
What kind of paint are you going to use? PPG,DuPont? The flat clears are A LOT easier to spray than normal clears just dont tiger stripe them and use a good gun like a Satajet. I need to start doing my car again. Also if you use flexibilizer on all of you undercoats and clear coat, and use basecoat activator in you basecoat the paint will be more chip resistant and will last much longer.
__________________
Seth
94' Barcelona Red w/ Tricoat black 2-tone AWD Ls - Sold
Mods:AWD conversion/4.44 swap by Budfreak, Custom red interior lights, Custom Satin black dash, Power mode switch, Cold air intake, Permecool tranny filter,Sony xplode 10" sub, Sony xplode 1000w amp, Blitz in-line driver, DDM Tuning 6000k HID's, New paint job/body work by me, 97' Grill, QC shift kit, 17'' MB Motoring rims, 15&20 min mod, front & rear urethane swaybar bushings, Custom fiberglass sub box, Custom red led a/c control unit, perrin lightweight crank pulley, Black wrinkle finish powdercoated intake manifold w/ clear hoses , 02' outback heated/power black leather seats
Soon to come: Fiberglass hood, upholster ALL suede to black leather
Past subies:
92' Pearl White/black top LS-L-SOLD
96' Legacy Outback-TOTALED
99' Legacy Outback Limited 30th anniversary edition-TOTALED
98' Forester L -Totaled
Other toys:
99' Forester S -WRX brake upgrade, soon an 04 wrx motor swap
06' B9 Tribeca-Stock
1982' Yamaha xj650 Maxim
Mods: work in progress
Last edited by redlightningsvx; 08-14-2008 at 04:36 PM.
|