Re: speaker wiring diagram???/
hi today did some more troubleshoot of the problem i am having i get a echo sound in my speakers like the are not getting enough power from the hu
some time they crackling sound when they cut out. but at times they work great and sound good when i wiggle the wire from the jvc harness that sometimes help contacted sonic electronics about this and put in for a return.
my question is if i have a 4 channel car stereo
Amplifier
KW-XR810
Maximum Power Output
50W x 4
Continuous Power Output (RMS) (CEA-2006 Compliant)
20W RMS x 4 CH at 4 ohms and no more than 1.0% THD + N
MOS-FET Amplifier
Yes
Audio DAC
TI/Burr-Brown 24-bit DAC
Yes
Source-Specific Volume Control
Yes
Volume Attenuator
Yes
Balance/Fader Control
Yes
EQ
3-Band Parametric iEQ
Yes
Loudness Control
Yes (3 patterns)
LPF/HPF Cross Over
Yes
HPF
Yes
Max. Amp Gain Switcher
Yes
Front AUX Input
Yes
Line Output Terminals (Pair)
3 Pairs (Front + Rear + Subwoofer)
Subwoofer Output with Level/Frequency Control
Yes
Load Impedance
4 ohms (4 - 8 ohms allowable)
Line Output Impedance
1 kohms
Subwoofer Output Level
2.5V
will adding tweeters with out a crossover or with one put too much stress on the head units amplifer causing it to fail.....?
|