Quote:
|
Originally Posted by Myxalplyx
What a pain in the arse this connection is. The throttle body housings are so close together. You need thin rubber or silicone to squeeze two intake tubes on it. Have to do something about this in the future. Now, I'm waiting for the 'Y' pipe to arrivein the mail. The single pipe portion of the 'Y' is where I will drill hoses for the vacuum tubing. After I receive the 'Y' pipe, I can figure out the length of the straight tubing I'll need to connect the silicone bend to the 'Y' pipe with. Then the tubing and hoses will get all clamped down.
Just my little update since I've nothing else to do.  |
What if you cut the cuffs off of a stock airbox and slid your intake ducts in one end and clamped them then slide the cuffs onto the throttle bodies and clamped them?? Have you thought about the 90's ford trucks for a 2-1 intake fitting? Look at the bottom right hand corner of this page:
http://www.summitracing.com/catalogs...nfeb/358f.html
Just thought I'd throw some ideas out there.
Let me know what you think.