[mile-hi-bri]

Crash,
I just pulled my shafts,(tranny coming out, again). I used a 3/16" drift punch to tap the pins out. Even a medium sized phillips screwdriver would work fine. NOT hard to reach or very 'stuck'. Very simple.
I personally don't undo the '3 bolts'. I undo the control arm mounting points instead. It is a 19mm socket to undo the bolts going thru this point and a 17mm to undo the rear cradle bolts. This will make sense when you're under there. Just don't undo both sides of the cradle at the same time. Just do one shaft, then the other. Good lock!!
mile-hi-bri