*** Doing Rear Subframe Any Pointers ***
Bought most every bolt, washer, bushing, nuts and caps OEM
SSP should provide Rear subframe with trailing arms
Going to ask for support plates
New calipers
Hopefully sway bar and brackets
* Now as far as I know the frame is bolted to the body
The axel shafts shouldnt have to leave the diff
Nor the gas tank
-prob use ramps, jack stands, etc.
Do I have to remove the exaughst ?
Will I need any special tools ?
Do the bearings have to be pressed into hubs ?
*Can I use clamps to rewind calipers and
does proportioning valve need to be reset
Pnuematically if reservoir goes empty ?
Any knowledge would be welcomed thanks
Tommy 1996 LS-I -Polo Green - #467
|