|
theres two boltts under the lower cladding, 4 scross the top, and two more behind the corner light. Also theres one in the door jamb, as well as a few clips for the cladding that need to be popped out CAREFULLY to acess all the bolts
The process is the same for both sides
Check the area behind the damge to the fender to make sure everything is as it should be, and when placing the new fender on, get all the bolts started and finger tight...just tight enough to where you can move the fender around and it stay where you put it. next, slowly close the hood and door. Push the fender around as needed, then open the hood and door and tighten the bolts. Double check everythings placment before putting the cladding and corner light back on
__________________
R.I.P Cool Signature. You're gone but not forgotten. I mean, sure, I kindof don't remember some of the finer details..but I remember you were funny, and at one point you said spaghetti in Dutch....but definantly not forgotten
|