|
Re: Engine will be pulled
At the risk of sounding stupid - Yes I DID use the Search button - Where can I find some info on the "Flex plate upgrade (from 2mm to 3mm)"?
I'm about to pull my engine to hopefully only have to replace the front transmission seal. All of my tranny blood spilled out from under the torque convertor. This would be the perfect opportunity to do the upgrade if it's worthwhile.
Thanks in Advance,
Dan
__________________
Dan
Pentiums - Melt in your PC, not in your hand!
Project - '92 Claret - Purchased May '06, 99,XXX Miles. Includes two bad engines and one bad tranny, cracked windshield, otherwise mostly complete.
His - '92 Ebony Pearl - Purchased Dec '05, 134,687 Miles. Parked, TC Seal(?) is leaking. Daily driver - 140,500 and climbing.
Hers - '92 Teal - Purchased Aug '05, 129,050 Miles. Daily driver - 160,000 and climbing.
Mods:
PWR Radiator!
Problems:
Antenna doesn't work - Bought a 'new' one - Too cold to install . . . OK, it's warmer but I have other projects too! 
Ticking from front of engine, passenger side - Stuck lifter?
|