This one...
1. Warm up engine by driving at speeds greater than 12mph.
2. Stop vehicle and turn ignition switch OFF.
3. Turn ignition switch ON and make sure POWER indicator lamp comes on.
4. Turn ignition switch OFF.
5. Move selector lever to D and turn manual switch ON.
6. Turn ignition switch ON.
7. Move selector lever to "3" and turn manual switch OFF.
8. Move selector level to "2" and turn manual switch ON.
9. Move selector lever to "1" and turn manual switch OFF.
10. Partially depress accelerator pedal (to turn idle switch off).
11. Check code as displayed on POWER light. Blinking once every 1/4sec is normal.
and this one
1. Warm up engine by driving at speeds greater than 12mph.
2. Stop vehicle and turn ignition switch OFF.
3. Turn ignition switch ON and make sure POWER indicator lamp comes on.
4. Turn ignition switch OFF.
5. Move selector lever to "1" and turn manual switch ON.
6. Turn ignition switch ON.
7. Move selector lever to "2" and turn manual switch OFF.
8. Move selector gear lever to "3" and turn manual switch ON.
9. Move selector lever to "D" and turn manual switch OFF.
10. Partially depress accelerator pedal (to turn idle switch off).
11. Check code as displayed on POWER light. Blinking once every 1/4sec is normal.
Neither one works.
Is the idle control switch tied to the TPS?
__________________
Patrick
1995 Ebony Pearl. S.N. 0001 "Araby"
JDM Power Mode Switch, Integrated GPS/Video Player
6Xk Miles.
1992 Teal - Sold to Mysvxrocks
[SIGPIC][/SIGPIC]
|