Gear Firm-Up Unit Schematic
Someone was after a Gear Firm-Up Unit.
So I would like some people (more than one) to check my reverse engineered schematic of an existing unit - see posting number 8.
If there is a general requirement for PCBs then I could get some bare boards made (supply a BOM so that individually you can buy components from your local electronics shops such as Jaycar etc)
__________________
1995 LSI, Added the following - Gear Firm-Up unit (that I sell) together with Power TCU ROM & Power switch, K&N air filter, SVX side badges (USA type), Rear Deck Blower (JDM type), Side front markers (USA type), Side rear markers (USA type), Middle rear light (USA type), USA OEM Fog Lights fitted into NZ OEM glass (NZ OEM headlights had only reflectors fitted) Full set of yellow (90SH) Polish bushes includes 15 min mod, R1 Concepts drilled/slotted/gold finish rotors & Red covered braided brake lines (both from Dayle at Motorsport warehouse), EBC Redstuff brake pads. Full SVX bra (only used for shows). Koni adjustable inserts fitted inside OEM strut body, Zoom lowering springs (2" lower), OEM headlight washers fitted.
Last edited by SURTEESS; 11-01-2016 at 03:01 PM.
Reason: updated pdf attachment
|