Quote:
Originally posted by lee
If for some reason they use a 2252 Ohm thermistor, then all you would have to do it tap into the lines coming from the tranny to the TCU and run them to the gauge. I can tell you which lines (gotta look it up though), but the probe and gauge have to be of the same type.
thanks for the offer.
|
Hi Lee, Don't forget that the signal from the NTC sensor is an analogue signal, going to an A to D converter in the TCU. If you load the line up too much, it will corrupt the TCU's temp info.
Make sure that it is well buffered, CMOS interface?.
Harvey.