Quote:
Originally Posted by Dessertrunner
Ahve a 5 speed and put switch between pin 16 torque control and 5 v and got no difference in power. Also messured the voltage on the ECU end of 20 and got 5 v anyway so tell me does the pwer come from taking pin 20 to 5 v or ground because I don't seem to be able to tell. Haven't tried grounding 20 as not sure if safe.
Tony
|
Tony the line from the TCU is held high, 5V, when the TCU wants Torque cut, it pulls the line low, 0V. I think most just leave it unconnected. I would wire it to 5V, to prevent it from giving any problems. Of course where you can get the 5V from,,,,I'll have a look and get back.
Harvey.