|
Re: OEM amplifier question
Harvey, yes I remember that addition that you sent me - now just got to find which box it is located in (from about 30 boxes - each about 300mm x 300mm x 300mm).
I wanted to ground the A4 pin in order to turn on the "POWER" indicator ....... will this work with the ROM you sent me ?.
Attached is a picture of the NZ (left) with JDM (right)
Harvey, do I place your ROM into the empty space and then remove the IC above it ?.
__________________
1995 LSI, Added the following - Gear Firm-Up unit (that I sell) together with Power TCU ROM & Power switch, K&N air filter, SVX side badges (USA type), Rear Deck Blower (JDM type), Side front markers (USA type), Side rear markers (USA type), Middle rear light (USA type), USA OEM Fog Lights fitted into NZ OEM glass (NZ OEM headlights had only reflectors fitted) Full set of yellow (90SH) Polish bushes includes 15 min mod, R1 Concepts drilled/slotted/gold finish rotors & Red covered braided brake lines (both from Dayle at Motorsport warehouse), EBC Redstuff brake pads. Full SVX bra (only used for shows). Koni adjustable inserts fitted inside OEM strut body, Zoom lowering springs (2" lower), OEM headlight washers fitted.
Last edited by SURTEESS; 01-22-2019 at 06:34 PM.
|