Quote:
Originally Posted by STiLtd683
Thanks for the fast reply, Nate.
The shaft is properly clipped.
The input shaft is sticking out 1 1/8". Is that fully seated?
And the torque converter feels like it is seated but the torque converter, more specifically the wings that you bolt the flex plate on to, is dragging at the bottom when I spin it.
|
When fully seated, the TC should be sticking out just past the bellhousing. (maybe 1/4") I can't recall offhand how far out the input shaft should be. I just remember I recently had an issue with the input shaft requiring more force to fully seat which was then causing the TC to not seat fully.