|
Re: Valve cover gaskets - How the F do you get the cover back in place??
Quote:
Originally Posted by immortal_suby
It's a puzzle.
On my wife's svx I actually jacked the engine up slightly and then it slid right in.
On mine I just had to maneuver it quite a bit and then it finally fit.
|
This is good advice, use a block of wood between the bottom of the oil pan and the jack. Also as Chris said you should have some gasket silicone on the corners anyways, many here have had bad leaks on the corners right after install if they didnt use the silicone, and it will help the gasket stay put. As fun as the VC gaskets are, you dont want to do them twice.
__________________
Chris
"A person convinced against their will, is of the same opinion still"
 New?? Find the downloadable SVX Online Service Manual Here
 RECOMMENDED READING for newer SVX owners Here some cool info if not fully accurate.
|