View Single Post
  #5  
Old 07-20-2015, 07:08 PM
SVXMAN2001 SVXMAN2001 is offline
Registered User
 
Join Date: May 2001
Location: long island, NY
Posts: 2,033
Send a message via AIM to SVXMAN2001
Re: Bent Hub and/or Knuckle Assembly

The front driver's side angle pic and passenger/driver's side rear II's pics are probably the best examples of the height difference.

The front driver's side angle gives a great pick of the significant negative camber as well.

Again the driver's side is so out of wack that it can't be aligned properly and ride height is 1/2 an inch lower than the passenger side.

Additional note is that the driver's side rear was so out of alignment that the inner half of the tread was almost gone after only a few thousand miles on practically brand new tires. The shop I took it to bored out the strut bolt holes to get more play and force it into alignment. Clearly a patch to the symptom as if that guy ever goes out of business I'll never get it aligned again!
Attached Images
File Type: jpg Passenger Side Rear.jpg (174.5 KB, 135 views)

Last edited by SVXMAN2001; 07-20-2015 at 07:11 PM.
Reply With Quote