I don't know if it's for front wheel drive specifically, but the set-up it lists in the HubTamer manual IS for the front bearing! I had to figure out myself which specific parts to choose for the rear bearings (as Beav confirmed). I'm sure it would have cost me more than the $200 cost to have the dealer do it here.
IS THE NOISE I'M HEARING (INFREQUENT, NOT TOO LOUD) PROBABLY THE FRONT BEARINGS?
THANKS!
__________________
Jim
1995 Laguna Blue SVX AWD L - 240K (daily driver) -
"ReBuILT" used engine at 236K miles (6/13)
2013 Veloster Red - Driver Now??Dropsprings [1/2" rear, 1" front] with Koni Strut Inserts> Magnaflow Exhaust System>
ECUTune Stage 1av1 Upgrade (from 1v4)>
ECUTune TCU MOD> Aluminum Crankshaft Pulley> Stainless Brake Lines> Phenolic Spacers>
Perforated Brake Rotors (dint like, OEM now)> SmallCar Shift Kit (resting since TCU MOD)> 7-Position Ground System>
High-Pressure Fuel Pressure Regulator (resting)> ATF Cooler & Campaign Filter> Yellow Polish Polyurethane Bushings> Pioneer Double-DIN Stereo with JL AUDIO Speakers>
Driveshaft Rebuilt with C-Clip U-Joints>
15 Min MOD>
20 Min MOD .. . (2011)
Valentine One Radar Detector with Remote Display - ucan'tseeme!