[Bonestock]

I am loving this 3M carbon fiber film. I wrapped a bunch of stuff yesterday. You can tell I got much better the more I did so I am going to re-wrap the gauge cluster. Those compound curves were hard. It didn't help that I was up till 2:30am and had to get up at 6:30. I am tired!

Pjcs aren't good. And I was too tired to care. The flash makes the "Wood" color stand out for the HVAC but its not as bad in normal lighting. I think I am going to try again but use masking tape and trim the lettering then apply the film. Once heated the outline of the masking tape should show under the film. The I can use an exacto and cut perfectly! I'll try that tonight. I didn't notice it but I also have the film in the wrong direction on one part too. Add that to the re-do list.










I even wrapped the top of my computer desk!