Re: 11:1 Engine Rebuild
You'll want to go ahead and clean your deck and gasket flanges now too. The best thing to use is surfacing pads on a die grinder. That's basically a scotch brite disc that goes on a rotary tool--usually a die grinder but you could use a drill if you had to.
Follow LAN's advice here, re the tools to use. You'll eat up your dremel if you try to use it on this.
-Bill
__________________
Retired NASA Rocket Scientist
Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023
Center Network Member #989
'92 Fully caged, 5 speed, waiting for its fully built EG33
'92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension
'92(?) Laguna, 6 spd and other stuff (still at OT's place)
My Locker
|