Re: 3rd and 4th gear are not engaging + weird smell
.
See the attached .pdf file. It is a Subaru bulletin 078 on instructions for using a transmission pressure gauge.
http://www.subaru-svx.net/forum/atta...1&d=1537500132
Transmission Line Pressure Test With Vehicle Stationary
Line pressure measurement (under no load - closed throttle)
(1) Before measuring the line pressure, apply both foot and parking brakes with all wheels chocked.
(2) Maintain the temperature of ATF at approx. 70 80°C (158 176°F) during measurement. (ATF will
reach the above temperature after idling the engine for approx. 30 minutes with select lever in N or P.)
Line pressure measurement (under heavy load)
(1) Before measuring the line pressure, apply both foot and parking brakes with all wheels chocked.
(2) Measure the line pressure when select lever is in R, 2 with engine under stall conditions.
(3) Measure the line pressure within 5 seconds after shifting the select lever to each position. (If line pressure
needs to be measured again, allow the engine to idle, and then stop it to cool down for at least one minute.)
(4) Maintain the temperature of ATF at approx. 70 80°C (158 176°F) during measurement (ATF will
reach the above temperature after idling the engine for approx. 30 minutes with the select lever in N or P.)
3) Temporarily attach the gauge to a suitable place in the driver's compartment, make or remove a blind plug
located in front of the toe board and pass the hose of the gauge to engine compartment.
4) Remove the test plug and install the gauge fitting instead.
5) Connect the gauge to the hose.
6) Check note values in accordance with throttle position.
Normal line pressure run between, 44 - 189 psi.
Drive Throttle fully closed 44 60 psi
Reverse Throttle fully opened 220 249 psi
(2) Throttle fully opened. 164 189 psi .
__________________
.
Subaru Ambassador
1996 Polo Green LSi #216 ..138,100 miles. ..SOLD
JFICX8659TH100216.....Date of Manufacture: November 16, 1995.....
Fuji Heavy Industries..Ōta North Plant....Ōta City,. Gunma Prefecture, Japan
In-Service Date: January 2, 1997
"The Pristine Green Polo Machine
First Polo Green on the Network
First Clear front turn signals, JDM Alcyone hood emblem, rear panel, and BOXER engine cover on the Network (US) (2000)
First 5000K HID factory fog lights (2007)
First SVX JDM BBS wheels on a USDM SVX (2013)
HID lighting (5000K) for headlight and H3 fog lights, PIAA SuperExtreme 120W high beams, rebuilt EG33 longblock, Cometic head gaskets, Phase II flexplate, AMR aluminum radiator with custom silicone hoses, 160A high-output alternator in aluminum-ceramic coated case, new design alternator wiring upgrade v.4, rare factory headlight protectors, refinished JDM BBS mesh aluminum wheels and custom, polished billet aluminum new hex center caps, LED grille mod, R1 Concepts high-carbon cryo slotted rotors, Akebono ceramic pads, Goodridge S/S braided brake lines, Smallcar Stage 1 shift kit, ThermalTech aluminum/ceramic-coated valve covers, Energy Suspension urethane front & rear swaybar bushings, Bontrager22 rear swaybar with QS Components Chromoly Teflon/Kevlar endlinks, "$15.00/5 minute" suspension mod. Hella Supertone horns, Custom stainless steel exhaust system with 2" headpipes, Magnaflow cats, AeroTurbine AR25 resonator /AWD "Bullet" muffler.
R.I.P. 2010 Subaru Outback Limited 2.5 CVT...338,000 miles. Totaled by a 1,300 lb. COW March 4, 2016
2014 Hyundai Avante Limited ...178,000 miles. Actually quieter and smoother than the Outback
2007 Mazda Miata MX-5 PRHT...102,000 miles.
Plenty of parts, service and windshields.
4th Registered Network member 2/21/2001
My NEW locker..I...My Email..I..Wikipedia/SVX .
.
Last edited by svxcess; 10-23-2018 at 03:48 PM.
|