|
Re: empy din slot idea
I think I have decided to make a custom cup holder...or, at least, try to. The idea is to get a simple pocket for the upper din slot after putting the new, single din, radio in the bottom slot. Then, to get the clearance Huck mentioned above, I will make a custom holder out of an aluminum sheet and four pieces of foam rubber. The cup holes will be cut out of the aluminum sheet and the sheet can be made long enough to extend out so that the cups don't interfere with the dash. This would just push into the pocket.
Right now, there are no arms in the plans for under the cup. I suppose I could attach some brackets under the smaller hole for water bottles.
__________________
Tony
1996 Polo Green Subaru SVX LSi, 168,XXX miles, Redline D4 ATF, Redline 75W90 gear oil, K&N HP-4001 Oil Filter, Mobil 1 5W50 FS (3qt) and 5W30 High Mileage (4qt) Oil Blend, Motul RBF600 Brake Fluid, AC Delco A975C Air Filter, NGK BKR6EIX-11 plugs, Centric Rotors, Power Stop Evolution Carbon Fiber Ceramic Brake Pads
2005 Gray Acura RL, 165,XXX miles, Redline D4 ATF with Lubegard Platinum Protectant, Mobil 1 5W20 High Mileage Extended Performance Oil
2009 Red Toyota Venza, 123,XXX, Mobil 1 5W30 High Mileage Oil
1992 Red Ferrari 348 ts, 82,XXX, Redline everything
|