[svx_commuter]

Hi Huck

When I get this done I may follow in your foot steps.

What's the bearing inside the fork called? It feels shot when I spin it. The balls are wron out. How do I change it? There appear to be little wire clips holding it in.

The clutch assembly is attached to the back of the engine. Do I just unbolt it? 4 bolts. Is anything spring loaded in there? Anyway I could get hurt?

After the 4 bolts rae off, does it come out in one piece or several pieces?

Any special tools needed for reassembly? Are there alignment pins for centering the clutch to the engine? It looks that way to me.

Is there another bearing in the engine for the tranny shaft?

Thanks