[JDW-SVX]

Originally Posted by AUSVX

1 - Connect to the battery charger detection wire (use the positive). This is the factory recommended connection

That wire is the brown one on the two-wire connector, located on the left-hand side of the alternator. The wire is grounded when charging voltage is not present, and is left floating when charging voltage is present.

Originally Posted by AUSVX

2 - Connect to the engine oil detection wire (use the positive)

That wire is the single one (yellow with a black stripe) coming from the oil pressure switch, located on the front of the engine block, just below the alternator. The wire is grounded when oil pressure is low, and is left floating when oil pressure is normal.

Originally Posted by AUSVX

3 - Five coils around high-tension coil (not sure what this is)

That won't work - the SVX uses coil-on-plug ignition, so you will not be able to wrap a coil around the ignition coils.

I get worried when I see an SVX on the back of a tow truck - what happened?



Jason.