|
Re: SVX towhitch?
Very easy to make . the hardest part is drilling the holes into the rear suspension arm. The space is cramped . I used a right angle drill. As said above .. You bend a 18" long piece of 1/4 3" wide steel plate at a 90 deg. you weld a 6" piece to the same stuff to bottom of the end sticking out .Drill a hole in it . Take a piece of the same stuff and bolt it to the 6" piece and make it long enough to reach the rear of the car between the hold downs . The square tube is cut just a 1/2 shorter than the distance between the tow rear hold downs. Weld taps to the ends of the square tube and fasten it to the hold downs then weld the long flat piece to it add the receiver and you are done SEE pictures and read this at the same time Go to my locker ans see pictures I have towed my motorcycle 70 miles on a 5X10 trailer
|