|
Re: cam sprocket tool of choice
Quote:
Originally Posted by svxfiles
I built my own. 
I took a flat 1" wide, 3/16" thick, steel bar stock, 18" long, drilled tapped for two 10mm X 1.75 bolts,2,1/4" center to center at one end, with a slight bend in it.
The bolts protrude, 1/2", and are welded into place. |
Tom,
Any issue with placing a socket on the sprocket bolt? Does your holder get in the way of bolt? Is the 1/2" of bolt enough for the left sprocket, would 1" to 1.5" work better?
I used a 24" breaker bar, the bolt I removed was way tight.
Dave
__________________
LS-L 92 black top silver bullet-Turned into a 2005 Jeep TJ Unlimited
2012 Outback 3.6R Limited! 
Last edited by dromano; 08-02-2008 at 10:57 AM.
Reason: addition
|