Re: Swapped EG33 issues
It runs...............
................but I'm not sure why.
This morning I went through all the grounds I could find and cleaned them up but to no avail. The engine still lost #1 then #2 after a few minutes idling. Then I scrunched the wiring harness in the engine bay and it ran on 6 cylinders again. At least I think that's what I did; it happened so quickly. It has run flawlessly all day despite me un-scrunching the same wires again a few times. I could untape that section and see if I can find a loose wire but I'd rather like it to go back into fault mode again to see if my scrunching had the effect I think it did or whether it was it the grounds.
Thanks for all your input and help.
|