11-17-2012, 06:53 PM
|
|
1995 Subaru SVX LSi Polo Green
|
|
Join Date: Jul 2005
Location: Grantham, PA (Near Harrisburg)
Posts: 2,119
|
|
Re: Tail center light bar foam replacement
What I did was that I used black electrical tape around all the edges of the bar and the back tail lights so that all the water run down to the bottom near the bumper where it should go.
__________________
-Jason
(8/23/07-Present) 1995 Subaru SVX LSi (197k) Polo Green (#1102) 03/95
Mods: DDM Tuning 4500k 35w Low Beam HID, 100w H3 Bulbs, Extra Ground Cables, 15 minute $12.96 mod,
svxfiles designed transmission mount (), sporting a "new" tail light bar,
silver BBS rims, custom power steering cooler (one that doesn't dump ATF constantly), new negative lead cable, no more third or fourth gear
(1977-Present) 1977 Chevrolet Corvette (81k) Silver
(12/01/2011-Present) 2005 Subaru Outback 2.5i Limited 5MT (97k)
I have a bad feeling about this.
-Obi Wan Kenobi
|