This seems like a perfect thread to join based on my current situation. The picture showing the location of the two knock sensors shows the top of the engine removed. Is this the manifolds? Can I safely do this with regular tools. I started to replace both sensors last night. I removed the alternator and I actually replaced the one on the left. The one on the right has proved to tough. I used my extension to remove the old one but I can't unplug the wiring. The plug is basically over twelve years stuck in there. The one I replaced I had to chip away at the old sensor plastic plug to get it out. I definitely need more room to get at this sensor on the right. Please give me any suggestions on what I can do to finish this job. The one on the left that I replaced I wasn't able to get my torque wrench on it to tighten it properly just an end wrench. Thanks.
Mike
