Quote:
Originally posted by immortal_suby
I've pulled them out a few times with just a twist and a large flat bladed screwdriver gently prying on the plastic part.
|
Matt,
Where exactly do you pry on the plastic part?
Thanks.
-Bill
p.s. I checked out a Q45 site (their fuel injectors are the same as ours - basically - except they flow 370 cc) and the consensus appears to be to grap the injector with bent nose vise grips - firmly, but not so much as to crack the plastic - and pry against the vise grip with a screwdriver while pulling up on the vise grip. Think I'm going to try to fabricate a tool to act as an extractor....
__________________
Retired NASA Rocket Scientist
Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023
Center Network Member #989
'92 Fully caged, 5 speed, waiting for its fully built EG33
'92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension
'92(?) Laguna, 6 spd and other stuff (still at OT's place)
My Locker
|