[NiftySVX]

I need to build a panel like that for mine. I am considering switching back to analog and using a mechanical pressure gauge to measure main line, but am worried about having a pipe running ATF into the cabin.

Are you using custom software? Or is the JDM tcu different? I thought that over temp & light was 220. I know you mentioned the two stage overheat which is a new bit of info for me.

As we discussed, I have never seen or heard of anyone heating the fluid in the pan to that level except for one who's trans was slipping very bad and was trying to get home.

I am not sure why I didn't think of it, but I should have put my sensor inside the pan and run the wire outside with the main loom.

Are you using a stock TC? I should send you my old level ten one.