|
you're very welcome.
One clarification. I expected all the wires to be making contact. There should be one thin one. Try putting a little pressure on it to make it bend slightly back toward the center of the gear. It isn't that it bends over time so it doesn't make contact, it's that it bends so it isn't contacting the right part of the copper plate on top of the gear. The result is that instead of coming out at 90 degrees from the side it comes out at like 91 degrees - enough to screw it up.
Anyway, it can be tested out of the car by plugging in the harness and watching it work (or not). At this point it's a free test, so....
|