Quote:
Originally posted by DavieGravy
I'm going to spend some more time with it before our Colorado meet. I'm actually a little embarassed over the amount of dings I have and would like to do some more.
Hey Randy, If I use your technique, do you think I'll be able to get the smaller dents out? Also, what would make a good tap down tool? A rubber mallet perhaps?
Thanks.
|
The "tap down" tool, shown with the kit, looks like it's nylon. It's shaped like a crayon (tapered to a semi-point at one end, flat on the other). I'm guessing you use a mallet to tap the tool and return the extrusion to "normal." Just a guess.
__________________
Randy Johnson
3rd Registered Member 02-21-2001
First Member to Reach 10,000 Posts
First to arrive at the very first Reading Meet
Subaru Ambassador
1992 SVX PPG Pace Car Replica 110+k
1993 White Impreza L 240+K miles
2001 Legacy Outback Limited Sedan 250+K miles
2013 Deep Indigo Pearl Legacy 3.6R 49+K miles
"Reading is my favorite Holiday"
Mike Davis -- at Reading VI
|