[spinn360]

Well I replaced the TPS and still the check engine code came on so I thought I would try adjusting it and when I checked white wire and ground the voltometer was showing 1.50 and as I adjusted it only went from 1.4ish to 1.8ish no 0.5v no way no how. So what do I do now??? why wouldnt it show 0.5v or anywhere near 0.5? I cleared codes and am going to run it again to see if anything comes up the power mode thing hasnt happened so maybe the new tps fixed that but maybe there is something else throwing both 02 sensor codes?