if I remember correctly, you have to turn the cover. The tab on top is a good place to slip your finger behind to pop the cover off once you have turned it.
Then remove the connector that attaches to the wire. (you'll see when you get it open)
Then there is like a spring clip that holds in the bulb that you squeeze off.
Be careful not to touch the bulb with your fingers. The oil in your skin isn't good for bulbs when they get hot.
If you're having a hard time with the clip that hold the bulb, try some needlenose pliers.
__________________
-MikeECUTune2v7 - 4.11 5 Speed - Sprung 6 Puck Clutch - D&S Rotors - SS Brake & Clutch Lines - HKS Panel Filter - HeaderBack Exhaust -80GB Hard Drive - GroupN Engine Mounts - - some other "tricks"
[SIGPIC][/SIGPIC]
In progess: track down mystery noise <-identified, paint the new dash, get better pic
Spring plans: Replace Trans - Integrate ECU with the carputer - Suspension - Go back to STI Filter - Paint? Maybe not - Next Oil change: Purolator L30165
Member #995 | My Locker | My New Locker
Catch you next at: ? Auto-X ?
Last edited by Speedklix; 01-22-2005 at 06:24 PM.
|