|
troubleshooting airbag errors
As part of my 5MT swap, the airbag connector on the steering column was disconnected when the steering column was removed to get at the firewall. After reassembly, the airbag light is lit up on the dash when the car is running. I checked the airbag fault codes, and its reading code 11 (Fuse #8 blown, faulty control unit, open circuit in main or body harness) and code 12 (Roll connector circuit is open, faulty CU, open circuit in main or module harness). I've disconnected and reconnected the airbag connector several times, checked the airbag fuses, and tried clearing the codes, but the error codes persist. Any suggestions on where I can do to fix the airbag errors?
__________________
Mychailo
:: 2006 Silver Mitsubishi Evolution 9, E85, 34 psi peak, 425wtq/505whp DJ ::
1995 Laguna Blue SVX L AWD 5MT (sold)
Visit my locker
SVX Mods: ND iridium spark plugs, Impreza RS fpr, afr tuned to 13.2:1 using a custom MAF bypass, custom exhaust, WRX 5MT w/ STi RA 1st-4th gear & stock WRX 5th gear, Exedy 13 lb flywheel & Sport Clutch, STi Group N tranny & engine mounts, urethane spacers in rear subframe, rear diff mounts, and pitch stopper, SVX Sport Strut Springs (185f/150r), custom 19 mm rear swaybar, urethane swaybar mounts, Rota Torque 17x8", 225/45-17 Proxes 4 tires, Axxis Deluxe Plus organic brake pads.
|