Howdy folks,
The SVX has been off the road for nearly a year now, and I finnaly have a garage to work on it in.
So far, I've removed the intake plenum (want to replace knock sensors, and hoses under there, also makes it easier to reach the tranny)
Removed the front axles, rear axles, exhaust, rear end, driveshaft shield.
Question is, can I now remove the tranny mount safely or will the whole engine tranny assembly tip backward? What should be supported, if anything while removing the mount? Once that is done, is supporting the engine by the oil pan enough to keep the enigne from tipping forward?
Thanks for the help
-Patrick
pics:
http://www.subaru-svx.net/photos/fil...e7en/37205.jpg
http://www.subaru-svx.net/photos/fil...e7en/37206.jpg