Quote:
Originally Posted by irox
Hi,
I got a chance to pull the trim and check the resistor.
I get 1.3 Ohms, with the leads providing about 0.3Ohms of that.
So, seem like it's a 1 Ohm resistor.
Hope that helps!
Ian.
|
Special thanks Ian, removing the trim must have taken some time.
The reported problem:-
(1) “When I got the engine running normal, I would unplug the fuel control module from under the deck lid, yet the car would continue to run normally.”
(2) “Yet when I unplug it (The resistor), the car starts. When its plugged in it does not.”
Ian, unfortunate that I have to call on you again but only then can we move forwards as the situation is completely confusing.
I must ask you to please confirm that the resistor was disconnected when it was measured.
Again thanks, Trevor.
.