[oab_au]

Originally Posted by Uncamitzi

so..... thinking back I hadn't checked for CEL codes....turns out it's throwing a

13 Cam angle sensor No signal from can angle sensor,
but signal from crank angle sensor 1

any way to check if the sensor is bad if the wiring shows continuity?

Thats the one on the side of the engine. Pull it out and see if there is any metal filings stuck on the surface. The book does not state any resistance checks for the sensors windings, but it should be more than 1k ohms.

There is a magnet in there, that may be too weak.

Harvey.