[svxistentialist]

Originally Posted by Wikedjuggalo

Alright, I had some wire laying around and about 10mins of free time. I gotta say I notice a difference. Shifts in 3 are at about 4k RPM , and D are about the same. I Feel it "Get up and Go" better. Now If I had the time to figure out how to get a button worked into the this. I know the manual Button but again I don't wanna disable that and solutions to that?

I'm glad it's working well for you.

You could actually get along without a switch if you wanted to; if Manual is switched on [MANU on the dashboard] then Power will not operate in 2 range or 3 range.

If you set cruise on, then Power mode does not work in D either.

If you really want a switch it is easy to do. Run the earth wire from Pin A4 to your switch, then from the other side of the switch, connect to ground. The switch interrupts the ground circuit. You need to use one of the Push once is on, Push again is off type switch.

Joe