Quote:
Originally Posted by TomsSVX
Bill, check the site.. can you give me a map of where I need to go to order it??
Tom
|
Tom,
Catalog page 3495. It's a two part urethane.
Just make sure you seal the bottom of your "mold" so it doesn't leak out. You can also wait a little bit (maybe 2-3 minutes) for it to start to set up in the can before pouring it. This is what I've used for my "Gruppe N" trans and dogbone mods. Old Tom used it when he made his rear diff bushings.
-Bill
__________________
Retired NASA Rocket Scientist
Most famous NASA "Child" - OSIRIS-REx delivered samples from asteroid BENNU to Earth in Sept. 2023
Center Network Member #989
'92 Fully caged, 5 speed, waiting for its fully built EG33
'92 "Test Mule", 4:44 Auto, JDM 4:44 Rear Diff with Mech LSD, Tuned headers, Full one-off suspension
'92(?) Laguna, 6 spd and other stuff (still at OT's place)
My Locker
|