Quote:
Originally posted by Chicane
Also: Yes, I 'thought' my raceconcepts rotors were warped...but rotors don't ever warp.
Read this whole page:
http://www.stoptech.com/whitepapers/...otors_myth.htm
Basically, you overheated your pads, and your pads were probably not really good pads. Get some Axxis MM or Ultimates. It shouldn't happen again.
- Rob
|
So, My question then is: If I put ithe rotor on a milling machine and then check the "Run Out" if the needle/guage makes contact one side and then on the same side then your turn the rotor 90%- 180% and makes no contact.....what is that?