Thread: Loose Regulator Cable
View Single Post
  #2  
Old 06-18-2014, 07:01 PM
immortal_suby's Avatar
immortal_suby immortal_suby is offline
Thread Killah
Alcyone Gold Contributor 		 
Join Date: Feb 2001
Location: Greenville, SC
Posts: 5,835
Registered SVX
Re: Loose Regulator Cable
There is a nut/bolt on the regulator (similar to a bike brake cable adjustment) but I'm not sure it will have enough travel to get out the amount of slack you have. You might have a cracked plastic idler pulley, a cracked guide for the cable covering ends, or the cable is just stretched. It could also be slack enough that the cable is not winding correctly on the regulator motor - if it is too loose it will not stay in the tracks on the regulator motor pulley which can cause it to bind up.





__________________
Matt
Locker Link
2015 BRZ Limited 6MT
92 Ebony LS-L ECUtune Stage2av1, Z32 MAF, 370cc injectors, TomsSVX intake, BontragerWorks 22mm RSB #003, HID Hi and Lo beams, OT endlink and bushing mods, PWR Aluminum radiator, Harvey's QC shift kit, 2.5" flowmaster 80 exhaust, 17" Michelin Pilot Sport A/S, Poly sway bar bushings, Slotted Bradi rotors, AFBeefcake powdercoated calipers, 97 grill, and a huge set of air horns. 300,000 miles and counting
92 Ebony LS-L. ecutune stage1v4, motorsport 1pc pulley. Garage Queen - sold to Dad in upstate NY 155,000 miles
19 Subaru Ascent Premium - -Hers !.
89 DL 4x4 little red wagon - a.k.a. The immortal suby. 275k R.I.P.
Last edited by immortal_suby; 06-18-2014 at 07:05 PM.
Reply With Quote