Quote:
Originally Posted by newkid17
ok just did that tom... im getting 11 (Duty Solenoid A) and 33(Vehicle Speed Sensor 2) what is the 2? front or rear?
|
The code11 will alter your gear shifts but not like you are describing. More often than not the code 11 is caused by the dropping resistor behind the battery. So get out there with an ohmmeter and test the resistor.
Code 33 which is VSS2 is the front sensor you mentioned earlier. Probably remnant of when the sensor was not connected.
So at this point, go test the resistance of the dropping resistor and then disconnect the battery for at least 20mins. Replace the resistor if resistance is too high or the circuit is completely open or closed. Reconnect the battery, install new resistor if needed and test drive again. Pull the codes again. If the resistor is good you may need to replace the duty Sol A for line pressure, but as I said, more often than not, it is due to the resistor being bad.
Tom