Quote:
Originally Posted by TomsSVX
they were saying it was safe to 1000 hp not that it was going to make it. OT has mentioned of a shop in the pittsburgh area he had spoken to and i asked him if he could re-connect with them and see what its gonna run. So I wait... which is probably a good thing
Tom
|
AR Fabrication mentioned that they would do this as a project. Were not real forthright about a price though, since they have never done one on our motor. They are very good at sleaving subaru motors though, so I'm sure it would not be major learning curve with ours.
http://www.arfabrication.com/