|
The tranny temp is really easy, depending where you put it and even then it is. on the back of the gauge itself there is three posts and the hook up for the light. THere is the ignition post, a negative post and the sensor post itself. run one wire to the fuse box for the ignition wire, i used ato fuse taps to hook it in to the fuse box, then run two wires through the fire wall into the engine. one is for the negative, i screwed it into the metal. Then the other one goes to the tranny cooler. with the gauge there is a sensor that goes into the line going into the cooler. it is sort of like a T fitting. the wire coming off the gauge ties into that sensor and it is all done. hook the light into the illumination fuse and all done. It took me a while to do cause i couldnt get through the firewall. but i finally went through inside the wheel well, i pulled back the guard and went in through there. comes in down by the fuse box.
hope this helps.
Jerad
|