don't know if there is/isn't a front bearing how to....but
Beav is the originator of a trick that has you remove the three bolts at the bottom of the lower A-arm. This allows the hub to be pulled out enough to get the axle out without disturbing the ball joint and eliminates the need for a realignment. A diligent search will turn up a bunch on axle removal - then it's just a matter of knowing how to use the hub tamer.
basically,
remove wheel,
remove axle nut,
remove 3 bolts,
remove pin on transmission end of axle,
remove axle,
use hub tamer to R&R bearing,
reverse,
live happily ever after - or until you need the car again,
(whichever comes first)
|